Re: Waste cardboard, paper, newspaper, as feedstock #feedstock

Shaked From

Hi Rob,
thanks for the questions, I’ll try to answer best I can.
I’m also just about to run another burn as material is piling up, I’ll be able to share more pictures, what is the best way to do that?
I’m sharing land with an organic market gardener, and waste cardboard seem to be an abundant resource.

in terms of your questions:
1. The picture with the bones at the bottom was aimed at showing the bottom of the kiln, I don’t tend to place the bones at the bottom as it’s the place receiving least heat, and bones do not seem to char well there.

2. I usually start with a bottom layer of sticks, to make sure that the flatness of paper does not block any air intake, the sticks allow even distribution of air. The picture showing the sticks also shows the next layer up of rolled cardboard, starting the stacking from the outside and not yet complete in the center, the sticks are only at the bottom layer.

3. Stacking the rolls of cardboard, paper, newspaper works well, and does not seem to matter upright or horizontal.

4. Nut shells or tree bark when available work well as a complete layer.

5. Bones, egg shells, fruit stones, avocado skins and other such material seem to char best scattered evenly through the paper/ cardboard mass in the top part of the drum.

6. In terms of the design of the kiln, I have seen ‘aqueous solutions’ using both of the approaches, the 2nd drum as a chimney or a third of a drum attached to a flue as a chimney, I chose the later as I had the flue and it seemed lighter and easier to remove at the end of the burn.
i followed their design exactly, and I am very happy with it, I have used TLUDs before, and this one is the cleanest burn homemade TLUD I have constructed and used.

7. Regarding the question about my satisfaction with the resulted char... I’m not sure, which is why I shared this material to start with.
its all charred right through, including the bones, has no smell or taste, washes off easily with a bit of water, soaks up liquid well, and powders without effort, but I had not managed to find any information on the structural characteristics of paper/cardboard char, and I had not run any field trials.

i have been using that char in 2 main ways:
1. Mixed with grass clippings or wood shavings in our composting toilets, so every time someone does their thing they add a handful of the mix into the chamber, once full it sits for six months to decompose, red worms are abundant in the chamber too, after six months the compost is used in the garden or as part of seed raising mix.

2. Our family lives from the farm animals and our garden, and urine is an important resource.
my understanding is that each liter of urine has approximately 10ml of N, and that bacteria consumes approximately 5:1 C:N, so I either mix 50ml of humates with every liter of urine, and that’s spread onto the garden / forest garden (diluted).
Or the urine goes into the dry paper and co. biochar to soak for a few days, then the liquid (black urine) is watered into the garden, and the saturated biochar is forked into the garden soil.

i should run some simple field tests.

as well, I read somewhere about a characterisation project? Aiming to link feedstock, pyrolysis method and resulted biochar?
I had not managed to find the database, is this in existence? Common knowledge to this list? How would one get access to the information? And has anyone seen some info on the structural characteristics of paper/cardboard biochar?

hope I clarified a few points.. :-)

happy celebrations
which ever you carry

Join to automatically receive all group messages.